Elite EL25 Installationshandbuch Seite 20

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 30
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 19
Microphone/ Speaker / Multiple Units Set-Up
Microphone/ Speaker / Multiple Units Set-Up
O
f
f
O
f
f
On
On
On
Off
O
f
f
O
f
f
On
Off
Off
Adjust Microphone / Speaker Volume
“Multiple Unit” Set-Up
For more information refer to the Keypad Programming Manual
For more information refer to the Keypad Programming Manual
Allows the visitor to hear the resident at the unit.
Factory Setting for the Speaker is “5”.
Adjust Speaker Volume:
18
Allows the resident to hear the visitor at the unit.
Factory Setting for the Microphone is “5”.
Adjust Microphone Volume:
19
If you make an error during the programming sequence,
press the asterisk key (
*
) to start the programming sequence again.
Set Microphone Level
(0=Mute, 1=Low....10=High)
2 Short Beeps
Will be Heard
3 Short Beeps
Will be Heard
Enter Programming Mode Factory Password Programming Sequence
Set Speaker Level
(0=Mute, 1=Low....10=High)
2 Short Beeps
Will be Heard
3 Short Beeps
Will be Heard
Enter Programming Mode
Exit Programming Mode
Exit Programming ModeFactory Password Programming Sequence
Up to seven (7) EL25s can be installed on a single telephone line.
Each
unit must have a
“Unique
Unit ID”
number and the
“Number of Units in Chain”
assigned to it. Unit ID #1 is always connected
to the residence.
Unique Unit ID Sequencial Order
Number of Units in Chain “7”
Unit ID “1”
Residence
Unit ID “2”
Unit ID “3”
Unit ID “7”
Telco Entrance Box
Demarcation Point
Set
Unit ID
(1 to 7)
Set Number
of Units
in Chain
(1 to 7)
2 Short Beeps
Will be Heard
3 Short Beeps
Will be Heard
Enter Programming Mode Factory Password
Programming Sequence
This must be performed on
each
unit in the chain.
Factory Setting is “Unit ID 1” and “Number of Units in Chain 1”.
Set the Unit's ID Number and Number of Units in Chain:
2
Note: The visitor can adjust the speaker volume on unit with this key.
Unit will return to programmed volume setting when call is complete.
Exit Programming Mode
Page 19
Seitenansicht 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare